Search results

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    Floor drains ?

    On the water: Perhaps a fine mesh wire grate over the current grate.
  2. D

    Sea Nymph 14R drain plug question

    I've used vaseline on the rubber on my compound bows over the years and have never had any issue with a reaction or anything. I use it to keep the rubber conditioned and from dry rotting. I'd also make sure it isn't leaking from the outside of the assembly rather than the rubber seal. If that's...
  3. D

    help with identifying the make of a boat?

    23..oh...only 12ft v boats that i bought to duck hunt from
  4. D

    help with identifying the make of a boat?

    so most boat makers will make a 12 foot model that small?
  5. D

    help with identifying the make of a boat?

    Hey all, I don't have pics of the boat, but the PO painted it and painted over any marks on it identifying it. I was just wondering if anyone has seen a boat like this before, it's 12 ft long, 36" beam, and has a transom height of 15 inches. I'm just wondering because I've never seen a boat...
  6. D

    My 14' gamefisher modification

    I like this a lot actually. I pretty much wanted to do this exact same thing with my 12ft gamefisher, however I think i'm going in a slightly different direction for duck hunting from it. Overall great though.
  7. D

    '83 Bass Tracker Revival

    I've read through this probably 10x. I seriously love it. Sorry to revive an old thread, but this is awesome!
  8. D

    1964 evinrude lightwin 3 horsepower stalling

    Totally took the carb apart today, replaced the gasket/oring thing a majig on the high speed jet (?) as it was totally shot and I hadn't noticed it until now. Also pulled out the bolt and screw that are in the fixed jet and cleaned that out well. All in all, it runs like a top again...
  9. D

    New to me Evinrude Lightwin - Speed Question

    i have a 64 lightwin on my duck boat! never checked the speed loaded with guns and decoys, but with my girlfriend and myself (around 320lbs) a full cooler with 18 beers, 5 gal minnow bucket, long shaft 55lb troller and group 29 battery (among poles and tackle) I push 7mph.
  10. D

    1964 evinrude lightwin 3 horsepower stalling

    CajunCooke!!! I have a question for you. I finally have time to watch the videos you posted and in video 5 you're discussing the small pin that the float pushes upwards when the carb fills with fuel. I noticed that you talk about a tinier pin that holds that small little needle onto the float...
  11. D

    1964 evinrude lightwin 3 horsepower stalling

    Hey all, I have a 64 evinrude 3hp lightwin that I just bought a few months back. Normally I fish electric only so today I took it out for the second time. First day I used it she ran like a dream, didn't stall at all, and trolled down to a small putter while I trolled all day for crappie. I...
  12. D

    Help 12' V hull aluminum boat needs seats

    I have a 12ft boat that is similar and I would put a deck like this on it in a heart beat. Just make sure the seat swivels because you can't walk to the sides of the seat. You'd have to sit on it, spin around, then spin around to get off of it. I stand on my middle seat which is pretty close...
  13. D

    1648 Lowe Refresh part II

    laying the hammer down with the 19!
  14. D

    1982 12-0 gamefisher Jon Boat

    I have a buddy that has one I could get a pic of actually. I believe it's 490 people and 620 persons motor and gear. 15hp limit.
  15. D

    1984 Starcraft SF-1616T Conversion

    I love the boat, keep up the hard work. I do think that the story behind it as well as the work put in will make that boat far better than any boat you'd ever buy. I feel like you could pop out the seats so long as you rebraced the hull. You have taken out small split benches that probably...
  16. D

    1984 Starcraft SF-1616T Conversion

    I love the boat, keep up the hard work. I do think that the story behind it as well as the work put in will make that boat far better than any boat you'd ever buy. I feel like you could pop out the seats so long as you rebraced the hull. You have taken out small split benches that probably...
  17. D

    YJs 1236 Semi V Mod

    Hurry up already, I'm getting anxious! All jokes aside, I love it. Question though, what size plywood is that? is it heavy? My boat that size had a weight cap of around 400 so I'd be nervous to deck that much, but it looks phenomenal!!
  18. D

    Weldbilt 1652v duck/family boat build

    i got 3 hooded mergs and a red head this year. thats it. awfullllllll season. winter hit so late the season was out when the hunting got good
  19. D

    hunting mods

    I'm in the same boat, no pun intended. I duck hunt first and fish to find spots to hunt. I built my boat with fishing in mind though because I do that a ton more than hunting, I get more out of the season than with shooting my gun. I just bought a new boat though so I will be rebuilding it...
Top