Search results

TinBoats.net

Help Support TinBoats.net:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. R

    Batteries in the winter

    So I have question about what to do with deep cycle and the engine starter battery when not in use, like during the winter months. I saw a battery maintainer at Target the other day and wandering should I get one for my two batteries or taking them off and placing them in the garage good enough...
  2. R

    1983 25hp Evinrude won't shut off.

    Hello I have a 1983 25hp Evinrude with remote start, it's on a 83 Rhyan Craft I've been restoring. I got the engine running had some carb problems but got them all worked out with some help from y'all, thank you. However I noticed that I could not shut the engine off with the key or emergency...
  3. R

    fish Finder help

    I need some advise on what brand and model of GPS I can get thats pretty good and under $200.00? I have a 1983 14' Rhyan-Craft I'm restoring and will be using in the Dallas/Fort Fort Texas lakes. I have never owed or used one, thanks
  4. R

    1983 25hp Evinrude running rough

    Hello Im hoping someone can help me figure out what's wrong with my Evinrude outboard. It sat for 4 years, so I put a carb kit on it, a fuel pump kit, new fuel lines. It starts right away idles good for a short while then starts to sputter and dies. Does anyone have any ideas?
  5. R

    1983 25hp Evinrude carburetor problem

    I have a 1983 25hp Evinrude outboard that's been sitting about 4 years. I tried to start it but would only run momenterly with starting fluid. I think it's the carburetor? Any ideas and how hard is it to put a carb kit in one of these? I have experience with lawn mower engines but are they much...
  6. R

    1983 14' Ryan Craft rebuild

    I bought this 1983 Ryan Craft with a 25ph Evinrude. I have been redoing just about everything on it but I'm looking for some ideas from some of you members with experience. here are some pics on the progress.The last thing I just finished tonight was the steelflex coating.
Top