My 15ft Grumman can with what I can only imagine was at one point in time a jet ski trailer. It’s a tilt trailer that looks like someone extended the tongue just enough to get the boat on. The transom hangs over the rear of the bunks by a good 6-8”, and the bunks are probably 10-12” over the end of the trailer. The tongue extends past the trailer winch about 18”, I took the winch post off last night and slid the boat forward until the transom is over the rear of the trailer about 5”, this puts the winch stand at the hitch coupler.
Right now the tongue is 8’ long, anyone see anything wrong with replacing the tongue with a piece of 3x3” (same size) .120” wall at 10-11ft long? I’d rather replace the piece that’s there entirerly and it would only cost $60-70 for the material.
Right now the tongue is 8’ long, anyone see anything wrong with replacing the tongue with a piece of 3x3” (same size) .120” wall at 10-11ft long? I’d rather replace the piece that’s there entirerly and it would only cost $60-70 for the material.