I'm considering purchasing a new alumacraft MV1648 ss.
I have a question on adding the flush fit 3/4 swivel seats. I'm a big guy 300lbs from what i have found on the installation its just 6 screws strait into the aluminum of the current seat. is that really a secure mounting?
how thick is the aluminum used in the seats both the split rear sear and the middle bench is there enough there that the screws wont strip out. (the hull is only .07)
ideally i would like to run 5 bases, 1 on each of the split seats in the rear, one on each side of the storage compartment of the center bench and one in the front. I would probably only take 2 seats on the boat but this way i have flexibility in where I put them.
I have a question on adding the flush fit 3/4 swivel seats. I'm a big guy 300lbs from what i have found on the installation its just 6 screws strait into the aluminum of the current seat. is that really a secure mounting?
how thick is the aluminum used in the seats both the split rear sear and the middle bench is there enough there that the screws wont strip out. (the hull is only .07)
ideally i would like to run 5 bases, 1 on each of the split seats in the rear, one on each side of the storage compartment of the center bench and one in the front. I would probably only take 2 seats on the boat but this way i have flexibility in where I put them.