TinBoats.net
The original aluminum boat site!
Jack plate with tilt and trim?
- Thread starter Blake
- Start date
Help Support TinBoats.net:
richg99
Well-known member
I think Panther makes one, but it is equally as pricey.
No simple, inexpensive devices around that I know of.
Some guys have found used T&T outboards and bought them. They then sell the one that they own. Pricey, too. And, it has the risk that the new engine won't be as good as the one they already owned.
No simple, inexpensive devices around that I know of.
Some guys have found used T&T outboards and bought them. They then sell the one that they own. Pricey, too. And, it has the risk that the new engine won't be as good as the one they already owned.
nccatfisher
Well-known member
- Joined
- Feb 4, 2013
- Messages
- 694
- Reaction score
- 4
I'll warn you ahead of time you have two choices if you go with CMC and have a Yamaha. You will have to make an adapter plate to go between the motor and the CMC unit or go with the bigger 130 unit from CMC. The Yamaha 25 bolt pattern is wider than most small outboards and will not fit the small CMC units. I go the adapter route. I have put several on.
beetlespin
Well-known member
nccatfisher
Well-known member
- Joined
- Feb 4, 2013
- Messages
- 694
- Reaction score
- 4
The old model 9.9 and a new 25 has a completely different pattern.
Similar threads
Latest posts
-
🔞😈Compre USD falsos ((Telegram......+1(720)593-8347))🎃👿- Latest: aintchristy
-
-
-
Has anyone made a homemade OB motor lift strap to hoist motor onto boat?
- Latest: Still Afloat
