Darkside
Well-known member
The UHMW adds about 2.5lbs per sf, so figure 3’x 15’ is 45sf or an additional ~115lb
Would have to guess on the weight of the screws... 2-3lbs?
We did this on a 2007 LoPro SCC, top speed when finished was just over 48mph. No sure if I could tell any difference in the turning without having the two side by side. Hoping this one performs much the same as that. We should know in a week or so.
Would have to guess on the weight of the screws... 2-3lbs?
We did this on a 2007 LoPro SCC, top speed when finished was just over 48mph. No sure if I could tell any difference in the turning without having the two side by side. Hoping this one performs much the same as that. We should know in a week or so.