muddywaders
Well-known member
- Joined
- Jan 1, 2014
- Messages
- 101
- Reaction score
- 0
Im in the process of changing the bearings on my Caulkins trailer.There is a lot of corrosion on the spindle where the seal rides and also two small holes.The dust cap has a grease nipple but no spring and cup like a bearing buddy.I am assuming the two holes provide relief when pumping grease into the hub because when I blow air through the holes it sounds like it goes into the hollow axle shaft.My question is if I add a speedy sleeve will it no longer be possible to pump in grease or without blowing the seal?